Bathroom Remodeling FAQ
How do I choose a bathroom remodeling contractor?
Will my plumbing be affected?
During installation – if you have a local water shut-off – we will utilize this to allow the rest of your home to maintain normal water pressure. If there is no local shut-off valve for your bath area – your home water may be off for a few hours time.
My bath wall has some water damage – can you repair this at the time of installation?
Yes. We can repair drywall damage as needed. A cost estimate will be based on the total area needing to be repaired.
Other Common Questions
What forms of payment do you accept?
We accept cash, checks, credit cards and offer a “90 days same as cash” program with a minimal deposit.
Cleaning Could Never Have Been So Easy!
The following cleaning instructions have been compiled for proper hassle-free maintenance.
General cleaning instructions:
For normal everyday cleaning, Luxury suggests the use of a mild soap and water, with a soft wash cloth. Use of scouring pads or abrasive cleansers will dull the surface. Should you wish to use a product not listed below, test on a small area in the corner of the skirt before applying to the entire bathtub liner. Always review individual cleansers’ instructions. Always rinse thoroughly after cleaning.
Recommended cleaner: “Dawn” dish soap & water, Formula 409, &
X-IT. Vinegar and water may also be used to soften water minerals. If you require a disinfectant, you may use Clorox Bleach diluted with water to sanitize the enclosure.
Do not use*
Original Clean Shower, Clean Shower for Plastic Showers and Glass, Soft Scrub, Dow disinfectant cleaner, Lysol disinfectant cleaner, acetone, Lestoil, ammonia, fingernail polish remover, aerosol cleaners, or scouring pads.
*use of the chemicals will cause a dull surface and/or an easily recognizable chemical crack. This will void your product warranty.
There is no need to use abrasive cleaners. Abrasive cleaners dull the gloss over a period of years. In extreme cases where the recommended cleaners do not work, use a Chore Boy or 3M Sponge pad. Make sure you only use the ones recommended for Teflon Surfaces.
Caution: liquid drain cleaners are recommended over powders and/or crystal; however, when using liquid drain cleaning agents, bail the standing water out of the bathtub and remove the drain plug. Use a funnel to prevent spills and apply the chemicals directly down the drain. Always make certain that chemicals do not come in contact with the acrylic surface. Use drain cleaners sparingly, so that they do not boil out and attack the acrylic surface.
Removal of standard drain plug:
Occasionally your drain may slow down due to hair, etc., in the cross bars. In order to remove the standard drain plug, you must:
1. Push it down in the closed position
2. Turn the knob counter-clockwise, and remove it. Under the knob there is a stationary brass peg;
3. Turn the peg counter-clockwise using a pair of pliers.
4. When you remove the peg, the drain plug will also come out.
5. Remove any obstacles from the crossbars.
If you have any questions or concerns, feel free to contact us at 614-721-3872 and one of associates will be happy to assist.